Silent
Knight's new line of manual pull stations feature high-quality,
die cast metal construction. They are available in either
single or dual action configurations with SPST switch,
and with wire lead or terminal strip connections. The
normally open contact, which closes when the pull station
is activated, is rated for 1 amp, at 125VAC, or 3OVDC.
The contacts are gold-plated to avoid risk of corrosion.
All models in the series have been tested by UL for
compliance to the latest requirements of the Americans
with Disabilities Act (ADA).
Features
- UL
Listed.
- CSFM
approved.
- MEA
(BSA) approved.
- ADA
compliant.
- Weatherproof
model approved for outdoor use.
- Single
or dual action
- Terminals
or wire leads.
- Key
reset models use same keys as Silent Knight enclosures.
- Surface
mount back boxes available.
- High-gloss
red enamel finish on die cast metal.
- Corrosion-resistant
gold-plated contacts.
Operation
The single action pull stations are operated by simply
pulling the handle on the front of the station as far
down as it will go, at which point the handle locks
into place and is easily visible from up to 50 feet.
A scored acrylic break rod is also supplied with each
unit for applications where that is necessary. The handle
is reset by opening the station with the hex wrench
or key, placing the handle in the normal upright position
and re locking the station.
On
dual action models, pushing the PUSH bar causes it to
rotate inward, allowing the PULL handle to be grasped
in a one-handed motion. The dual action models are also
supplied with break rods. Dual actions models are reset
in the same way a single action models.
The
weatherproof version of the pull stations is provided
with a gasket and die cast metal back box tapped on
one end for 1/2-inch conduit, for surface mounting.
|
